- Joined
- Mar 9, 2021
- Messages
- 10
- Reaction score
- 0
- Age
- 64
Good evening from the Netherlands.
Title says it all.
I have the scematics so that's ok.
That shows me to connect RX to a litte 4 contact connector of only about 5 x 2 mm. I do not have such a connector. It is to small to solder there.
Normally it is easy to spot pads to solder somwhere else.
There are pads ofcourse. Leads, beeper etc.
The text or letters don't help me with this one.
I can find pos. And grnd. But where to put the signal wire.
It is a Spektrum receiver with only ONE wire for s and tx ( for osd etc)
On other FC it had to got to the Tx pad and not receiver S
Hope someone can help.
Thanks.
Title says it all.
I have the scematics so that's ok.
That shows me to connect RX to a litte 4 contact connector of only about 5 x 2 mm. I do not have such a connector. It is to small to solder there.
Normally it is easy to spot pads to solder somwhere else.
There are pads ofcourse. Leads, beeper etc.
The text or letters don't help me with this one.
I can find pos. And grnd. But where to put the signal wire.
It is a Spektrum receiver with only ONE wire for s and tx ( for osd etc)
On other FC it had to got to the Tx pad and not receiver S
Hope someone can help.
Thanks.