First, when I arm my quad the motors spin and dont stop spinning unless I unarm or hit my failsafe button, what am I missing or haven't set right in Betaflight or on my Turnigy Evolution?
If I goto my motor tab in Betaflight I can move the master tab and they are all moving dead even with each other. But when I arm quad with my controller the motors start spinning, and I notice motors 1 and 3 (1090) are moving faster then 2 and 4(1070). If I give the quad pitch, yaw, roll once I let it go they go back to the unbalanced rpm. If I give it throttle and let off it, all the motors are going all over the place, but I'm not touching any of the sticks. I eventually flip my failsafe switch to cut the motors off.
I"ve flashed the esc's, I saw a video about calibrating motors so I did that, and nothing is helping. Any suggestions?
If I goto my motor tab in Betaflight I can move the master tab and they are all moving dead even with each other. But when I arm quad with my controller the motors start spinning, and I notice motors 1 and 3 (1090) are moving faster then 2 and 4(1070). If I give the quad pitch, yaw, roll once I let it go they go back to the unbalanced rpm. If I give it throttle and let off it, all the motors are going all over the place, but I'm not touching any of the sticks. I eventually flip my failsafe switch to cut the motors off.
I"ve flashed the esc's, I saw a video about calibrating motors so I did that, and nothing is helping. Any suggestions?