So I'm fairly new to this, I have an eachine wizard and have done a few mods so getting more confident.
Crashed it yesterday and didn't realise I had damaged the plastic on the xt60 connection and ended up reconnecting it back to front for approximately 2 seconds. Now when I plug it in the correct way round and arm the props the 2 front props spin fine but the rear ones just jitter around. Don't know where to start just need to work out what components I have damaged and the best way to go about it any advice would be greatly appreciated thank you very much.
Crashed it yesterday and didn't realise I had damaged the plastic on the xt60 connection and ended up reconnecting it back to front for approximately 2 seconds. Now when I plug it in the correct way round and arm the props the 2 front props spin fine but the rear ones just jitter around. Don't know where to start just need to work out what components I have damaged and the best way to go about it any advice would be greatly appreciated thank you very much.
Last edited: