So I’m new to fpv so building a drone was hard but got it done and now trying too get a rxsr to work I got it binding but when I go to Beta flight it is showing no movement from the transmitter
-What flight controller are you using
-have you updated the firmware of your R-XSR
-have you enabled the correct UART under Serial RX in the ports tab of Betaflight
-have you enabled serial rx and sBus (or FPort) in the configuration tab
A screen shot of you BF ports and configuration tabs would be helpful
Sorry, bf = Betaflight. In the receiver tab of bf, does your channel mapping at the top of the page show AETR1234. Also when you say you tried all UART's, do you mean you physically changed the signal wire or changed it in the ports tab. A close-up pic of how you have your receiver connected to your flight controller may help
OK this. You don't need to solder anything to these pads, you just need to solder together the left (SBUS) pad to the center pad. Just a spot of solder to join (bridge) them
Have no idea what that even means but this is about as simple as I can make it:
Look at the attached pic with the 3 pads circled. The 2 pads need to be soldered together as I've shown. This will give you sbus signal to the pad you have your receiver connected to.