Hello
I'm building my own drone right now and ordered the naze 32 rev 6 from hobbyking.
I've recieved it and started to test it out, when i tried to set up my reciever (Turnigy 9x) a problem started showing up. When plugging it in while the board still is only connected to the computer I couldn't get the readings to show up. After troublesshooting i noticed that the reciever didn't get power. When measuring the voltage between the +5V and ground that is wired to the reciever I only measured a voltage of ~0,5V.
I went too Hobbykings support chat, there they told me to try out with the battery attached, still didn't power it.
They thought the board was broken and sent a new one.
I recieved the new one and the same issue is still there, only 0,5V out to the reciever.
I would be very happy to get the answer if I'am doing something wrong and if there is a solution for it.
Best regards
Oliver
I'm building my own drone right now and ordered the naze 32 rev 6 from hobbyking.
I've recieved it and started to test it out, when i tried to set up my reciever (Turnigy 9x) a problem started showing up. When plugging it in while the board still is only connected to the computer I couldn't get the readings to show up. After troublesshooting i noticed that the reciever didn't get power. When measuring the voltage between the +5V and ground that is wired to the reciever I only measured a voltage of ~0,5V.
I went too Hobbykings support chat, there they told me to try out with the battery attached, still didn't power it.
They thought the board was broken and sent a new one.
I recieved the new one and the same issue is still there, only 0,5V out to the reciever.
I would be very happy to get the answer if I'am doing something wrong and if there is a solution for it.
Best regards
Oliver