I recently bought a eachine wizard x220s and a separate receiver (x6b). With this receiver, I wanted to connect my drone to my fs-i6s transmitter. When I got my x6b receiver, I found out that the wire from the flightcontroller (f4 v3 flight controller) had an end with 4 points. In my receiver, I can only connect wires with 3 points. Because of this, I cut the wire and connected it to a 3 points end. I connected the two wires with a terminal block. I also checked whether the wire were connected to the correct wires and this was correct. When I power up my drone, I can bind my rx to my tx. However, when I connect my drone to cleanflight and go to the receiver tab, I don’t see anything moving when I move my sticks on the tx. Could someone help me with my problem?
(btw on my receiver, I put the wire in the ppm. I also noted this in cleanflight). I also attached a photo so you could see the setup.
Thanks a lot for the help and sorry for my bad English.
(btw on my receiver, I put the wire in the ppm. I also noted this in cleanflight). I also attached a photo so you could see the setup.
Thanks a lot for the help and sorry for my bad English.