Recent content by mitchell.atheis

I vote against tiny whoop as the flight characteristics are very different if your goal is to better your acro skills Wizards are a good bit of kit, the x220s in particular just needs a new different set of props than the stock ones and it's good to go. The best thing I'd say to do is build...

Another thing if it's not prop/motors, are you using the charger that came with the Wizard? I wonder if it's not putting in the capacity therefore not giving you enough power for lift?

Also with the props off & armed can you tell the motors are all spinning in the correct rotation according to your Betaflight setup?

Are you sure you have the props all in the right rotation?

Need much more info than not taking off. In which way is it not taking off? Motors spin but doesn't lift? Does your tx inputs show on BF receiver tab?

Nice! I would love to have my quad with me, I'm in Bali for a couple of months, currently on Nusa Lembongan.

Yes You will need to do the firmware update on it, and to do that you will need the update cable that can be purchased

There is a free 12v pad on the PDB which is labeled on the board Sent from my ONEPLUS A3003 using Tapatalk

How can i prevent this from happening again ?

Okay to sumerise to try make this clearer. - when powered on i get half a startup sequence - all components 'look' okay with no signs of damage - i can still plug the drone into the PC and change some settings in beta flight - LEDs on FC all are working with usb connection but when battery is...

I know you can't see everything there but here is a image Sent from my ONEPLUS A3003 using Tapatalk

I can't see any black marks on the flight controller , but there is another board underneath (not sure of it's name) which i cant see. Is it possible my 2.4ghz receiver could be of fried as there is grass in there? When i connect the battery the LEDs on the FlySky FS - iA6B do light up . Sent...

Hi Davey, What is the problem here as i think i may have encountered the same issue recently. I landed my quad in some grass, disarmed the motors and a puff of smoke come from the middle of my quad. No smoke from ESC's or motors but all from the center, i can't see what was damaged unfortunately

Hi, I have a Wizard x220 that i have been flying for a couple of days. Come in to land after a short flight today and disarmed the motors just above the ground for the quad to land quite gently onto the floor. Once on the floor i disconnected the XT60 cable then a puff of smoke come out from...