Recent content by kris660

Our 2 noob builds inspired by JC's videos . RiP JC , you'll be greatly missed !!

Will definitely setup with multishot after reading above, now to wait on new motors and esc's to arrive o_O .

Thanks Jerry, will research and follow up here .

Hi all .. i decided to try dshot build , removed single cap from new ztw 30a esc's and wired t-motors rmrc (2205 /2600kv) using DYS F4 board . Got twitching motors on initial plug in of battery . Updated ESc's via BL Heli Suite and set motor rotation . Did motor test and motors 1 & 3 got...

thanks for info !! What flight time on average with current setup will i get with 1500-1800 mah 75c battery ?

hi all , finally got quad flying , some crashes but no major damage, changed props and was good again. RMRC zmr250 frame naze32 Rev6 / Betaflight Turnigy 4s 1300mah 45c Spedix 30A Hv ESC Emax 2205s 2300kv motors Dal 5040 V2 props Before: Power was bit rough and i could also see props stop...

Update: PPM signal from futaba rx didnt work with my naze32,i tried flysky tx/rx via ppm and works now.

Checked and Uart2 uses #3 pin on Naze board . I'm bit confused as to amount of pins required to be wired . Currently using only Gnd/+5v/#1 ppm from Naze Board (3 wires) which are wired to futaba receiver . Does Uart2 pin from my naze board also have to wired to Futaba RX ?

I'm unsure which receiver channel UART2 pin is located . Quad battery is plugged in .

Tried UART2 with same results on cleanflight . Just installed Betaflight and now I can turn on Serial RX via UART2. Tried ch 1 but still no response via RX

Cleanflight Ports -> UART1 -> select Serial RX , then Save & Reboot . After reboot SerialRX tab defaults to off position . Any ideas ?

Thanks for fast reply , My FP-R127DF RX dosent have any led lights but I've tested tx and rx by themselves with servo and they do work. Transmitter is set to ppm Naze plug is connected to ch1 Cleanflight is set to PPM Will confirm UART SERIAL settings .

Hi there all , first time posting here . I'm new to quad racing with a built zmr250 ,naze32/ cleanflight . I also have an old PpM futaba T7CAP tx with FP-R127DF rx I'm trying to get working . Via cleanflight I make a connection via USB but get no response via receiver tab . Is it possible to...