Recent content by Jamie34

Hi all, I am still new to this hobby and have been trying to get my drone up and running for about a month now. I have tried about everything, except when I plug my quad and battery into betaflight I am not getting any transmitter inputs. The TX i have is the frsky x9lite, and I updated it to be...

I only get 3 startup beeps... How would I make it be seen by the ESC? I have tried resoldering and no luck. I built this myself.

Yes this is what happens, so the ESC is fine which is good. Can you think of any reasons why it wont recognize it in BLheli? The other issue I am having is the transmitter not being recognized in Betalflight even though it is bound to the receiver, which is connected to Uart1 S.bus. Could one of...

Yes I have UART 1 set for serial RX, and in the Config tab I am set for Serial Provider and set to SBUS below that. In BLheli it says "found no valid esc configuration." I have tried about everything I can find online and am thinking the ESC could be fried. If it were fried would it be possible...

@HighTechPauper I have tried both versions of BLHeli, and still no luck. The reviewer is a fr sky and it is on the S.bus uart 1 port of the mamba f405 4in1. Yes I have checked the tick box. I have serial RX turned on as well, so not sure what the issue is... I’m not sure what more info to...

Please help, I am new to the fpv drones and when I plug in my battery the motors do move a little bit and beeps, so I assume my esc can't be fried? I got the transmitter bound as well (the green light is on on the receiver) but it isn't recognized in betaflight when I move the sticks or try to...