Sorry for this being a long post.
I have a 6s Merica and it has a Hobbywing 60 amp ESC and a MatekF722 FC. Ok it’s less than 8 flights new..my last outing my goggles showed black screen then no OSD with pic. I was able to fly anyway. Next day I was testing the the goggles with another drone and it was fine. I wasn’t back to the merica and wasn’t able to get the 2nd set of ESC beeps going and of course no pic in the goggles. Hooked to beta flight and typed status and it showed nothing wrong. I did notice when the FC was plugged into the computer/beta flight the ESC went through full sequence but when not plugged up to the computer it’s just partial sequence... any Ideas what might have changed within the first few flights to this happening? All the solder joints look good, wiring looks nice and tight. No crashes either..
any input would be appreciated.
I have a 6s Merica and it has a Hobbywing 60 amp ESC and a MatekF722 FC. Ok it’s less than 8 flights new..my last outing my goggles showed black screen then no OSD with pic. I was able to fly anyway. Next day I was testing the the goggles with another drone and it was fine. I wasn’t back to the merica and wasn’t able to get the 2nd set of ESC beeps going and of course no pic in the goggles. Hooked to beta flight and typed status and it showed nothing wrong. I did notice when the FC was plugged into the computer/beta flight the ESC went through full sequence but when not plugged up to the computer it’s just partial sequence... any Ideas what might have changed within the first few flights to this happening? All the solder joints look good, wiring looks nice and tight. No crashes either..
any input would be appreciated.