Recent content by Ustaach
-
NAZE32 Motor 3 Problem
Hahaha, Definitely I wanted to set him free to, at least Drones are allowed to roam around in this lockdown. I will put on the battery now and see what the performance would be like. I will update soon.- Ustaach
- Post #16
- Forum: Flight Controllers
-
Flight Controller not getting power from battery.
Remove all the external devices like Camera and receiver and Then check the FC Status led it might be that you have shorted out the Vcc and GND pins during soldering.- Ustaach
- Post #2
- Forum: Flight Controllers
-
NAZE32 Motor 3 Problem
I have Changed everything according to the video and checked everything, these are the list of things that I have Changed- -Flashed ESC With Latest BLHeli Firmware -Re-Flashed FC With NAZE32 under Betaflight -Checked the Motor Orientation as well as Prop Directions. -Calibrated throttle of all 4...- Ustaach
- Post #12
- Forum: Flight Controllers
-
NAZE32 Motor 3 Problem
I have Swapped Motor 3 Cable with other Motor 1 Connector and it founds out that Channel 3 Of the FC isnt giving out proper Signal as motor 1 that is been swapped with Motor 3 Is also working as same, Now to know that Channel 3 isn't burnt I paced the FC in Motor Override mode by Switching the...- Ustaach
- Post #10
- Forum: Flight Controllers
-
NAZE32 Motor 3 Problem
Thank you for your support and giving out such a great expressive tour of what to take note for. So I have used blheli_S Suite and re-flashed the EMAX30A with the Current firmware and re calibrated every ESC and Rewired it again to make everything clean and tidy as stated by you. So I am giving...- Ustaach
- Post #8
- Forum: Flight Controllers
-
NAZE32 Motor 3 Problem
My Configuration are EMAX - MT3515 EMAX - 30A ESC PROP - 13X4.7 BATTERY - RUNNING OVER WIRES RECIEVER -FLY SKLY CT6B- Ustaach
- Post #6
- Forum: Flight Controllers
-
NAZE32 Motor 3 Problem
Did everything, Nothing is working for me.- Ustaach
- Post #5
- Forum: Flight Controllers
-
NAZE32 Motor 3 Problem
Yes, I have tried by removing the propeller and moving the quad by hands, So the flight controller tends to rev. up the Motor 3 to some levels, Which are around 1270 or so.. I did another test by increasing the throttle to max without props which spins the motors to about 1850 but the third...- Ustaach
- Post #3
- Forum: Flight Controllers
-
NAZE32 Motor 3 Problem
I have Flashed Afroflight 32 With CleanFlight Firmware. Firmware - NAZE32 Ver- 2.2.0 Cleanflight - 2.4.0 So everything seems to be fine except that Motor 3 Is always at its base speed ie Channel 3 Of Naze32 Board, When I try to Override all the motors with Motor Calib Section then it works very...- Ustaach
- Thread
- Replies: 15
- Forum: Flight Controllers