Recent content by Themechnic

I had time to try this, the current isn't displaying still. It only reads 5v and no mah drawn....

That is if I am connecting a 4 in 1 esc. I used a multimeter to just check to see if the current pin was linked with the one beside the JST connector (RX1/CRNT). It shares continuity so I assumed I would not need to jump anything on J16. Also would my OSD and Betaflight only read 5v?

Hey guys, Here I am with more problems. FC Omnibus F4 v5 PDB matek fchub-6s RDQ 3-6S 32Bit DShot1200 30A ESC Betaflight 4.0.3 I am trying to wire the voltage sensor up so I can monitor it while I fly and from everything the instruction say and the all knowing internet I should just wire the...

Okay so update on this almost dead thread. I kept tinkering and flying and I was able to get dsyncs to go away along with keeping motors from getting too hot. For about a week. Out of no where desync, and my typhoon32 popped 2 caps. Immediatly, the quad fell to the ground. I am pretty much...

Update: Okay, new motor installed. Double checked for any unwanted grounds to the motor and flew it. This time I checked the motors... Again the same motor feels like it is hotter than the others. I have a good feeling that if I try to push this drone it will kill another motor. Probably the...

OOOOh I understand. Thanks for the info. Landing this thing until Tuesday...:(

Okay, I am kinda thinking it wouldn't be great to fly on it... The PIDs shouldn't be a problem. From what I understand it won't make just one motor hot, but all 4 would be hot. What do you mean "short the esc?" Do you mean the esc has a short in it? I continue to look it over looking for damage...

Update: I am definitely thinking there is something hardware related going on with this setup. From what I can tell the frequency change fixed a dsync issue that is occurring. Changed the following setting. Increased rates about 100 Changed from dshot 600 to 1200 Changed Demag from low to high...

Update. -Changed my PMW frequency to 48 instead of 24 in blheli. -Changed rates to 690 or so to roll and pitch. Ran a low battery ?(haven’t turned on osd and thought it was a charged battery) and it flew normally and actually flipped and rolled. No problems. I'll try to narrow it down from...

Yep, I'm on the latest and greatest betaflight.

Is there another way for me to calibrate? My FC had a little accident.... and I can't power my FC through the USB port, I have to plug a battery in. But everything works fine from there(flashing, tuning etc) I am definitely a noob so I just went with dshot 600, I will switch it to 1200 to see...

I'm running dshot600 so is there a need to calibrate? Also the fc has to have a battery plugged in to connect to betaflight. It has the latest blheli on it also.

Specs: Omnibus f4 v5 Typhoon32 Dys sanguk 2306 2500kv I've flown this drone for about 30 mins before experiencing this problem. I can fly around no problem but I can't do snap tricks of my front right has to do any " catching." So doing left snap rolls no problem but if I try a right snap roll...