Current sensor problem

[Themechnic]

Hey guys,
Here I am with more problems.

FC Omnibus F4 v5
PDB matek fchub-6s
RDQ 3-6S 32Bit DShot1200 30A ESC
Betaflight 4.0.3

I am trying to wire the voltage sensor up so I can monitor it while I fly and from everything the instruction say and the all knowing internet I should just wire the current sensor out on the pdb (3.3v ADC signal) to the current sensor in on the FC. Switch the setting in the battery tab to ADC and be done. Well it reads 5v pretty consistently. No mah drawn though.
I have attached how I have it hooked up. Let me know if I have missed something.
Thanks

 

[RENOV8R]

This?

 

[Themechnic]

This?
View attachment 3315

That is if I am connecting a 4 in 1 esc. I used a multimeter to just check to see if the current pin was linked with the one beside the JST connector (RX1/CRNT). It shares continuity so I assumed I would not need to jump anything on J16.
Also would my OSD and Betaflight only read 5v?

 

[Themechnic]

This?
View attachment 3315

I had time to try this, the current isn't displaying still. It only reads 5v and no mah drawn....