Recent content by mycivicsi05

No I know that is normal. If I fly the quad around then land it with it still armed and let it sit there the motors will start spoiling up higher and higher on their own without me touching the remote

took the quad out today flying for the first time. All is good except when you land and sit on the ground the motor start spoiling up on there own. Anybody have any ideas what it could be. I got got the quad flying after trouble with CF

Awesome thanks for the info. I was scared that there was something else wrong. It took me a week trying to figure this quad out and getting it working again.

Ok I see what you are talking about. I do have the props off but why doesn't it do it when you pitch forward or backwards

i arm the drone and motors spin but if hit the throttle then let off the motors start to spin faster and faster on its own and the

Only problem i am having now is that the throttle will not decrease. I arm the drone right stick works perfect. The left still yaw works but if i throttle it up then let off motor speed comes down then starts to speed up on its own. Does anybody have any ideas

Just wanted to say thanks again. I did some more digging and found that the controller aux switches were not set. I reconfigured the controller then hooked the drone up to CF and seems to be working now.

Ok thank for all your help

The remote that came with it is a FLYSKY FSi6S all the top switches has letters to identify them like SWA SWB SWC and SWD

when i am on CF the sticks are working but when i move the aux switches they are not doing anything.

Thanks for the info. I hope to get it up and flying been about a week of me trying all kinds of stuff and been searching the internet.

I went on the Holybro web page and found a setting page for clean flight made a copy and went into the CLI and pasted it. I got the crontroller sticks working but still won't arm

No i didn't make a back up didn't know how and i don't know how it was config. from the factory

can anyone help me with cleanflight. I am new to the hobby, bought a shrunken 250 and tried to hook up to clean flight would not hook up until i updated the firmware. I updated the firmware and now the quad will not do anything with the remote. The remote can see the quad power but that is it...