Recent content by febeks

Hi everyone, I am building my drone from scratch and I am worried I just burned my ESCs. I am using FC Matek F722 (Flight Controller F722-STD, Standard – Matek Systems) along with Matek FCHUB-6S PDB. As you can see on the picture linked on matek website, thats how I have connected my ESCs (4X...

Did you have same googles - Eachine EV100? Well, I will know more when I get my second googles on wednesday I believe, I ordered Aomway commander so if they dont show me any video, its most likely to be that VTX.

Hmm, I just ordered a new VTX so I really hope its just that. Btw, did your googles pick up the signal from vtx normally but u got just black screen? Or ur googles didnt pick the good signal?

Wait, what? :D

I soldered one those 3 wires to pcb, red to 5V, black Ground, yellow Video In, ..no change on googles...really no idea whats with it. I hope the googles are bad cause I dont wanna change pcb on the drone and re-do all the stuff to get drone working with new board.

Haha, good question, yes the cap is removed. Im going to solder it on the pcb pins instead of using the connector. Will see if it helps.

I have Kakute F4-V1.4 and there is 5 or vBat

Btw, if the camera needs input 12V and Im using 4S battery, should it be connected to 5V on the board or should it use battery voltage?

I doubt that brand new googles are fauty though. And I checked camera, it could not been damaged since it was disconnected mostly.

but signal goes through, especially the one for video...how can it be bad? also the connector...no idea what can be wrong there

So I found a manual for VTX and when I set it to any frequency, it definately finds the good frequency but no video. Now, since I soldered that camera connector, could that be bad or more likely camera? because I checked soldered pins and I get signal everywhere it needs to go...

Yes, I tried all, .. no video on any of them...

I have tried to find signal again and I left band and channel unchanged on the drone and did autosearch on googles 4 times and every time it found different channel.

Connectors are matching 100%. Well too bad there is no way to check the camera some other way.

Cant be the antenna. I have it exactly as its been shipped and I also checked it and it fits. Same for googles.