Recent content by DrRatts

Installed a new rxsr receiver into my drone with a Spracingf3 fc. Read the pinout incorrectly and wired my s. port wire to the 5v connector on uart2. Ground, 5v, and sbus out (wired to rx) on uart3. Realized my mistake and changed the s. Port to tx on uart2. Updated firmware and all that jazz. I...

I replaced the motor and the quad flies great! I guess it all came down to a bad motor!

I was wondering what the actual amp draw is compared to what motor thrust charts say. I built a quad with dys wei 2207 2600kv motors. I am using GEPRC 5040 v2 3 blade props. According to the motor thrust chart, with 4s and the 5040x3 props, it is showing max 32.7A. My ESC's are rated 30A with...

I am running DShot600. I switched the motors to different ESC's and the same motor acted up. Definitely the motor! I will try replacing the bad motor and see how that goes....just have to wait for the new motor to come in

After watching some videos I decided to test the motors on betaflight (props off) the one motor was stuttering and not functioning like the others... I'm guessing this is the issue which makes sense. Leave it to banggood to send you a faulty motor!!

Dropbox - GOPR2020_SPIN-OUT.mp4 this is what happens. This is not my quad but seems to be the same thing that happened to me!

I was in Horizon mode

I just built a quad and everything seems to be in order. I took it out for the maiden flight and it ended badly! The quad would hover completely fine. I could pitch forward, backwards, roll slightly left and right, yaw left and right, and fly in circles no problem. I then tried a full roll to...