Recent content by Conasty

I originally order parts cheaper that would of had 6 motors, larger bases, and clearer instruction. However the drone kit was mislabeling during shipping in china bc of the corno outbreak. I am currently designing this for an expo in my region for electrical engineering. Due to the time...

I would normally research however it seems like racing drones part I received do not have very good documentation in regards to datasheets. Here is the link to the part kit I ordered Amazon.com: LHI Mantis218 2019 Newest Race Quad ARF 218mm Carbon Fiber Frame F405 Flight Controller LHI 2206...

Ok I will do that for the time being. I follow those instructions. Also because im curious, what does the 1000-2000 range stand for. I assumed RPM but I was just guessing.

I have stable connection, I just do not have them soldered down because I am still trying to figure out the wiring of a flight controller.

Ok I adjusted it to Multishot, the motor ran correctly. The motor was spinning at a must slower speed before. When i changed back to DSHOT600 the motor would only run at 1910 again. Is there a reason I would be unable to use the multishot protocol?

I did not test all the motors because i do not have a proper connector at the moment. I tested two motors and both only make rotations at 1910. They would slightly move at some other levels but not spin. I will do the protocol swap and calibrate and see what happens.

If I had to guess the ESC name it would be, 2-45LIPO. says RS 20A. I do not know which ESC protocol im running. Like I said I was driving them with a PWM off a logic signal on a Pi. When I transitioned it beta flight the motor only spins at 1910 out of the 1000-2000 range.

I am working on my BS in EE. I am building a drone for some handicap member of my community. I am currently using a PDB-XT60 and HAKRC F405. I was driving my brushless stepper motor with a raspberry pi using a PWM. However I was informed that I would need to use the HAKRC F405 to control the...