Recent content by Alister Mac

I don’t have much experience but I did have the same problem with different hardware. My fix was resetting all parameters to defaults and saving. I reflashed the eprom at the same time so I can’t be sure which action resulted in a fix but it works now.

Thank you very much. Good info. The FC is physically oriented correctly. I went in to beta flight and reset all to default. I then reflashed the EPROM. After all that, something worked. I wish I knew what parameter was corrupted or exactly what the problem was but it works now. I still have a...

I am unsure where I’m betaglight to check the FC orientation. On the Configuration tab I see board and sensor alignment. But after a little trial and error I believe this is not what you are talking about. Please enlighten me.

Would a faulty motor cause a problem like this? I suddenly had 1 motor quit. It sputters a few times then fails. The other 3 then feel in sync. I will check Air Mode as well. Thank you.

Would a faulty motor cause a problem like this? I suddenly had 1 motor quit. It sputters a few times then fails. The other 3 then feel in sync. Will check the FC orientation in beta flight as well. Thank you.

As soon as I arm the drone, the propellers spin up and if I am on very stable ground the quad seems balanced and happy but as soon as it needs to comensate and make adjustments to prop speeds it gets a wobble that turns violent quickly. The props are on corrrctly. In beta flight when I check...

Turns out I had a bad 4s battery. Thank you

Thanks that seems to work. Now I have a different problem. I’m not sure if the last guy can help me although he did a pretty good job with the last one. So now I have full control of my drone. I arm it and slowly push up on my throttle, the blades spin fast, it clears the dust off the ground...

Did you try making sure the the aux port for arm on the mode tab was set correctly?

At first I had it on switch d but when that did not work I went to the mode tab and deleted the arm mode, saved and rebooted. My belief was that it would default to being armed with both sticks down and out. However it still won’t arm. Bf showing not armed also. Side note: I am not sure if a...

This is my first build so EVERYTHING is being learned on the "fly" HA Thanks to this Forum I was able to figure out that I needed to jumper the FC ibus pad and set my TX to PPM=ON. This was exciting because I now have control of my drone. At least according to the Receiver tab in Betaflight...

I have the exact same problem and the solder to ibus on the FC worked but only partially. I now have control in Betaflight. The Receiver tab shows me my receiver is talking to the FC. I have motor control but when I disconnect from betaflight my TX appears to do nothing. I am binded but it wont...