So I got used cinewhoop built by rotor riot. It’s tmotorf7 with caddx air unit and DJI 2 googles with DJI remote. Everything was working fine until I crashed from about 5 feet down. Managed to damage one of the motors. Replaced a motor and upon starting it won’t take off so I went to change direction of this motor in betaflight. Also updated to latest firmware 4.3.2 and now it won’t see controller. I did message rotor riot and they sent me full setup file which I used in cli. So everything is binded I get video in googles but controller not visible in betaflight so I can’t arm or do anything. I did order another air unit just to make sure it’s not an issue and it’s exactly same problem. I’m out of options here