Ok thanks very much! I'm gonna give it another shot this weekend. It's funny it seems like the smaller the quad the more difficult they are to build lol. I've never had as much trouble building my mini quads as I have with all my micros. I'll post back how it goes.You may be able to get 5v and 5vGnd from the Buzzer +/- on the tiny pepper, buzzers are usually 5 volts.
Ok thanks very much! I'm gonna give it another shot this weekend. It's funny it seems like the smaller the quad the more difficult they are to build lol. I've never had as much trouble building my mini quads as I have with all my micros. I'll post back how it goes.
Hey again! So I found some info from TBS on how to wire up the vtx and camera and I found some diagrams on the esc motor order. I have the tiny fish stack all wired up but only motor 2 spins and it is sporadic. I went into config and tried dshot 300 & 600. I also went into blheli to flash the escs and it says 1 & 4 are unknown or have been erased. I was able to flash the other 2 escs with no trouble but when I try to manually pick the same target that worked for those escs to flash the unknown ones it says flash writing block failed. When I go into the motors tab none of the motors spin except 2 and like I said it just randomly twitches. I'd appreciate any help. I checked all of the solder points on the esc and they are fine.Yup, miniaturization is expensive and difficult to work with, consider the desktop PC vs the laptop PC, same basic principles apply here, and think of it as going on vacation with the family, you can go in the Chevy Suburban or take the Cooper Mini, which is harder to pack everything needed into... the smaller one.