Hi guys,
Recently ive flown at my friends hometown abd everything was all good. Yesterday i went in the field and it didn't arm at all.. reciever light was on and the flight controller was medium speed flashing red light, i think there is a problem when the quad does its pre check.
Checked all the wires from esc to FC, cam (which worked) and VTX.
I plugged it into the computer and in betaflight it will not respond to my tx inputs, bars wont move..
Its betaflight 10.4 and firmware 3.5.0. I tried updating the firmware but when the process starts the drone doesnt do a thing, have to plug it in and out and then its 3.5.0 again.
Tried so many youtube troubleshooting vids and ended up with nothing.
I changed nothing on the tx because it had worked before, tiny whoop responded to the tx as its used to.
Thank you for your help!
Recently ive flown at my friends hometown abd everything was all good. Yesterday i went in the field and it didn't arm at all.. reciever light was on and the flight controller was medium speed flashing red light, i think there is a problem when the quad does its pre check.
Checked all the wires from esc to FC, cam (which worked) and VTX.
I plugged it into the computer and in betaflight it will not respond to my tx inputs, bars wont move..
Its betaflight 10.4 and firmware 3.5.0. I tried updating the firmware but when the process starts the drone doesnt do a thing, have to plug it in and out and then its 3.5.0 again.
Tried so many youtube troubleshooting vids and ended up with nothing.
I changed nothing on the tx because it had worked before, tiny whoop responded to the tx as its used to.
Thank you for your help!