Receiver s603 to an naze32 rev 6

[Siivaa]

Screenshot (2).png

• bhester91
• May 29, 2020

Screenshot (2).png

• bhester91
• May 29, 2020

hey just wondering if someone knows how to connect this receiver to an naze32

 

[theGreenOrange]

Screenshot (2).png

• bhester91
• May 29, 2020

Screenshot (2).png

• bhester91
• May 29, 2020

hey just wondering if someone knows how to connect this receiver to an naze32

Plug a 3-pin servo (dupont) connector to the PPM port on the receiver. The three wires go to the top 3 pins on the left side of this photo. One for Signal, one +5V, one Ground. Be sure you power the FC with 5V, otherwise you will need to power the receiver from a separate 5V source. If you power FC with battery voltage, it will fry your receiver using the "5V" pin which really supplies whatever voltage you power the FC with.

 

[theGreenOrange]

Previous post edited for clarity, and to attach photo.

 

[Siivaa]

@theGreenOrange ok thought i hade to get the ground and 5v into the batt on receiver so if i understand it right i just ned an 3 pin on the receiver with red in middle, black farest down and with closest the top

 

[theGreenOrange]

You should only need 3 wires connected to the receiver when using PPM. Batt pins aren't needed.