- Joined
- Aug 3, 2019
- Messages
- 141
- Reaction score
- 151
- Location
- San Jose, CA
- Website
- www.rprsolution.com
Hello gang,
I have an iFlight Nazgul5 4s version that I have been flying on a 5s, although I’ve gotten a bit of noise that a 400uF 50v took care. Recently, I’ve upgraded the motors to handle 6s, but I’m running into issues with the video transmission.
When using a 6s the VTX would cut off in split seconds during load and comes back to normal when I ease off the throttle.
Here’s the stack that it came with:
Main Flight Controller: SucceX-E F4 (BETAFLIGHTF4 Firmware)
-ESC:45A 2-6S BLheli_S DShot600
-FORCE VT5804 V2: 0/25/600mW Adjustable frequency 48CH with IRC protocol.
Since this rig is rated 4s is there a way to change the voltage output to accept 6s?
I have an iFlight Nazgul5 4s version that I have been flying on a 5s, although I’ve gotten a bit of noise that a 400uF 50v took care. Recently, I’ve upgraded the motors to handle 6s, but I’m running into issues with the video transmission.
When using a 6s the VTX would cut off in split seconds during load and comes back to normal when I ease off the throttle.
Here’s the stack that it came with:
Main Flight Controller: SucceX-E F4 (BETAFLIGHTF4 Firmware)
-ESC:45A 2-6S BLheli_S DShot600
-FORCE VT5804 V2: 0/25/600mW Adjustable frequency 48CH with IRC protocol.
Since this rig is rated 4s is there a way to change the voltage output to accept 6s?