Naze32 rev6

[FpvDemon518]

First thing first I am new to the drone world. I bought a robocat 270 and bought a Naze32 rev 6. I am seeing a 50/50 slip on this flight control being good and bad. So not sure if I should wire in the Naze32 or buy a different flight controller. I am using cleanflight to program the flight controller. Thanks

 

[VirtueViolater]

Did you buy it as a kit?

 

[FpvDemon518]

No piece by piece bought the frame first read up on the motors escs and the flight controller. The Naze32 seemed to be a common flight controller that people used but the more i read its a 50/50 on the Naze32

 

[VirtueViolater]

For 20-$40 you can get a fc that can run the latest firmware. The two best being Raceflight and Betaflight. You also want esc's running blheli s or newer

 

[VirtueViolater]

Betaflight is very similar to cleanflight

 

[FpvDemon518]

My escs are little bee 20a opto pro preflashed with blheli and using oneshot 125

 

[theGreenOrange]

I wouldn't wire it in. Betaflight is dropping support for f1 boards like the Naze. Grab basically any one with an f3 or f4 processor.

 

[raymonFPV]

Buy a new one. The rev6 is probably the worst flightcontroller out there. Buy a DYS F4 flightcontroller!

 

[FpvDemon518]

I looked around and found the flip32 for cleanflight looks easy to use has a port to hook up my lemon satellite Receiver not to much money around $25

 

[theGreenOrange]

For that much you can get a flip32 omnibus which has OSD built in.

Flip Series - Flight Controllers

 

[VirtueViolater]

or
https://www.amazon.com/Wolfwhoop-Be...&sr=8-9&keywords=omnibus+f4+flight+controller

 

[FpvDemon518]

Cool thanks