Logical Switch Question

[Torc]

I set up a two switch arm (sh+SF) and I'm trying to figure out if it can be set that a sound only plays if arming was successful, not anytime it's flipped.

I tried to I add LO1 to the mixer but was unable. Is this a possibility?

 

[HighTechPauper]

I don't think there is any indication that would tell the TX that arming was successful unless you can figure some way to read a telemetry value that might indicate running motors, but I cant think of anything off the bat that would do so.

 

[Torc]

That is the EXACT same thing someone I asked earlier said.

This would be only within the tx, no input from the FC. Just an alert that the switches were properly flipped.

 

[RENOV8R]

You may be overthinking things a bit. Firstly, if your quad is set up properly it should always arm. Secondly, the indication you get that you're properly armed is the fact that the motors spin up.

 

[Torc]

You may be overthinking things a bit. Firstly, if your quad is set up properly it should always arm. Secondly, the indication you get that you're properly armed is the fact that the motors spin up.

And exactly what I said to myself!

Glad to know I'm on the right track. [emoji16]

I thought I'd ask to see if it was possible but as you said, not needed.