- Joined
- Nov 19, 2019
- Messages
- 4
- Reaction score
- 3
- Age
- 23
I'm just getting into FPV and recently completed my first build. The goggles connect to the camera and my receiver responds to the transmitter in beta-flight. The motors all spin the correct direction when tested at low rpms in beta-flight. But when I tried to do my first hover, I couldn't get off the ground. The motors would arm and the quad would respond to little nudges of pitch and roll. When I throttled up, the motors would spin faster and faster until right before lift off, then everything shut down. The flight controller went dark and the motors stopped. The battery was still plugged in, but the quad was completely unresponsive. This happened every time I tried to fly.
The motors would cut at about a throttle of 1200 (1000-2000) in betaflight.
I am running the mamba f722 mini stack with a 100c 1500mah 4s battery. I have 2205-1800kv motors from Race Day Quads, a FrSky XM+ Receiver, and a taranis x7 transmitter.
Also I built my own lego frame, which is not the best frame, but it should still fly right? It does mean that the drone is heavy, about 540g with the battery.
The motors would cut at about a throttle of 1200 (1000-2000) in betaflight.
I am running the mamba f722 mini stack with a 100c 1500mah 4s battery. I have 2205-1800kv motors from Race Day Quads, a FrSky XM+ Receiver, and a taranis x7 transmitter.
Also I built my own lego frame, which is not the best frame, but it should still fly right? It does mean that the drone is heavy, about 540g with the battery.
Attachments
Last edited: