Bind Button Broken; BetaFlight work around?
- Thread starter Kspearson1
- Start date
Complete remove the filaments around the area where the button used to be. You can solder a wire and or use paper clip to short the terminal.
rtkDarling
Well-Known Member
- Joined
- Nov 1, 2018
- Messages
- 746
- Reaction score
- 1,139
- Age
- 41
The button just shorts the terminals. I used a tiny wire and just held it on with my finger last time, it worked fine
Hi,
I have the same problem with a broken bind button on a Blade Scimitar 170. By a miracle, the LHS was able to solder a wire across the terminals. It goes into bind mode and binds but just stays there because obviously I have to remove the wire. Which do you think is right: bind it and leave it powered up then cut wire or bind it, remove power, then remove wire? Thanks
I have the same problem with a broken bind button on a Blade Scimitar 170. By a miracle, the LHS was able to solder a wire across the terminals. It goes into bind mode and binds but just stays there because obviously I have to remove the wire. Which do you think is right: bind it and leave it powered up then cut wire or bind it, remove power, then remove wire? Thanks
droneguy
Well-Known Member
You can usually initiate the bind from Betaflight in the CLI. Depending on the version and firmware it will be bind, bind_rx, or similar. Use the help command to get the option for your version of the firmware.
