ZMR 250, CC3D filght controller, Librepilot, and Spectrum DX6i
Initial set up, I set the model up as Heli on Tx and multi rotor on Librepilot.During set-up wizard in Librepilot, none of the switches were recognized. Now, all switches need to be at "0" or the Tx just beeps at me, no Rx link. No prob once switches are at "0".
Flying has been good and I can adjust a lot in Librepilot, but now trying to set a dip switch for changing from standard angle mode to horizon or acro. Actually the idea of acro at full stick and horizon at less than full stick seems to be a good transition to acro.
Done some googling and U-tube but not much result. I seldom crash anymore and ready to move to the flippy stuff where I can routinely crash all over again.
Its probably simple for some of you folks but me not so smart. Can you point me in the right direction.
Thanks,
Dave
Initial set up, I set the model up as Heli on Tx and multi rotor on Librepilot.During set-up wizard in Librepilot, none of the switches were recognized. Now, all switches need to be at "0" or the Tx just beeps at me, no Rx link. No prob once switches are at "0".
Flying has been good and I can adjust a lot in Librepilot, but now trying to set a dip switch for changing from standard angle mode to horizon or acro. Actually the idea of acro at full stick and horizon at less than full stick seems to be a good transition to acro.
Done some googling and U-tube but not much result. I seldom crash anymore and ready to move to the flippy stuff where I can routinely crash all over again.
Its probably simple for some of you folks but me not so smart. Can you point me in the right direction.
Thanks,
Dave
