Welcome to DroneRacingPilots!
Join our free drone racing community today!
Sign up

receiver

  1. FrankV01

    Antenna Pulled off FrSky XM+ Receiver

    I just noticed that one of the two Antennas had been ripped off the receiver. How might I re-attach it? Can I solder it or should I replace the receiver? Mind you, it's only $13 so replacement is fine if that is better.
  2. H

    Receiver Mounting

    I"m using a FrSky R-XSR Receiver, but I think my question applies to most receivers.. what's the best way to attach the receiver to the frame? I"m currently using double sided foam tape, but that doesn't seem to do a very good job, and the receiver ends up being held on by the antennae that are...
  3. O

    Can't wire Turnigy receiver to flight controller

    Hi, I'm a total beginner to fpv quads and I've purchased a Spedix 250 Pro BNF just to get a taste of fpv. I have a Turnigy Evolution as well, but I cannot figure out how to wire up the TGY-ia6C receiver to the flight controller so I can bind it. The quad came with a 10 pin plug which I've...
  4. bmw546

    I accidentally cut my ar610

    i cut the long cable of my receiver specktrum ar610. (Like in the first 1/3 of the cable)
  5. Jack Ley

    New Quad, Connecting to Baseflite

    I just got an ARF Anakin Sky-Hero the other day, it just needed a RC, which I have, battery and receiver. After some frustration I finally got the receiver hooked up,(this is my first non RTF quad, so this all new to be) I bound the receiver to the my AT9 RC and then I wanted to connect to...
  6. D

    DJI Compatible Receivers

    Hello drone builders, I am about to start building my own drone for racing and have a spare DJI Phantom3 RC that I was hoping to use. However, I have been struggling to find a DJI receiver at a reasonable price (don't fancy paying $300 for a P3 main board). Can anyone advise/recommend a DJI...