Recent content by Yonzariq

Newbie here :) I had some range issues with my EV800D when flying indoors with my whoop, found out that diversity is not standard enabled and you need to switch to the diversity mode. Only found that out after randomly pressing some buttons as mine did not came with a manual...

I had some help yesterday and the issues are solved - Updated the drivers as I could not flash the FC, Betaflight would just disconnect the com-port - reflashing the FC stopped the issue after arming, motors do spin until I touch the throttle stick and the quad does not bounce all over my...

It only happens after arming, and stops when I apply a bit of throttle When controlling the motors through betaflight it doesn't happen, not even with all 4 on full power. Orientation looks good, quad image in Betaflight turns in the right directions when moving the sticks

Got it all built and wired last weekend, but I am running into a few issues. 1. From Betaflight everything responds as expected, but motors are in the wrong order and rotation, so I should use BLheli32 for this. But I can connect with BLheli32 as in, it sees that an ESC is connected, but I...

Some photo's :) First mounted the motors and test fitted the ESC to measure the motor wire length: Extended the motor wires and mounted the ESC: Wired the VTX: Soldered the Rx plug on the FC: Next up is soldering the ESC plug to the FC, but I am still unsure on where to connect VBAT and...

Ah great, I will ignore the CPPM output. Will upload some photo's when I am home from work :)

Started to look into soldering the ESC to the FC, but have a few questions... ESC has a 7 wire output, 8 in drawing, but I guess NC is not connected :) RacerStar REV35 4-in-1 anniversary edition: But FC, Mateksys0 F405-CTR manual only states where to connect - GND - IN1 - IN2 - IN3 - IN4 When...

TransTec Frog Lite frame: Newbie build

As I ordered a wrong one myself I need to pay shipping when returning, this is almost half the cost of the camera, so I'll just keep it for future use. And order the correct size for the quad. Hmm... keep it and throw it on a car. Sounds like a great plan :cool: So for now I started soldering...

Took some time but got all of the parts. Time to build :) Totally overlooked the fact that I ordered a micro camera, so I need to come up with some kind of spacers to mount the camera in my frame.

Ah well, I started with a very cheap FuriBee F36 micro quad a few weeks ago, just to try some flying. Now I bought a Taranis X9D+ SE and am trying some sims with it, and also got a FPV micro and larger 5 inch on the way.

I'd take a red one to fit with the rest of my build :D

Thanks for all of the info! I was actually guided to those props for this setup by a few other people, but will order a few of 5x4.0x3 props also. Ordered a load of shrink wrap and tape. Still need a few more parts and wiring before I can start building. Also I am new to the whole FrSky scene...

As someone completely new in drones/FPV I am in the process of slowly ordering the necessary parts while flying/crashing around my living room with some micro's :D Not searching for the real high end stuff, but good enough to keep me busy and learning for some time without breaking the bank...