I do have a volt meter and i did measure the volts going through when the battery is plugged in and the results are positive. It also isn’t the wiring because at the endpoints of the vTX and camera i’ve measured it too. So my opinion (what i hope) is that some kind of chip isn’t working thats...
Well, the camera doesn’t get to hot, it just gets a little warm, so thats not damaging, is it?
And yes, my head is also full of questions... Again i bought a new FC, so if it isn’t fixed by tomorrow then i’m out of options..
A little update. I tried what you said and tried what the youtube guy told.
I’ve put the red and black wire to the battery +/- . Cam is getting hot, but no signal again. Also tried hook up the vtx and camera wires together, also no positive result.
Im thinking it’s just the FC, according to...
Okay, yes it’s a little bit hard to understand all the information, but i appreciate it alot that u are trying to help me! So the wiring is bad... thats maybe because i swapped the camera and vTX pads, except for Video In and Video Out. Maybe i need to try to solder the camera and vTX to one 5v...
Ok, this is alot of information that i don’t understand too well! Sorry for that. But what u are saying about the 3 pieces that aint working is not true. When i plug the battery in, the vTX wil go on and so does the FC/PDB (actually a 2 in 1) and the esc will beep like normal. I flew a few times...
Yes i think i know what u mean. So i should put the batterie in and show u the vTX is working and the goggles? With the wiring? I already tried to switch the yellow wires. Well actually, i tried all possible ways to get the cam working... i thought i was losing my mind this afternoon..
Well, i had a cheap cam, so today i bought a better one, the Runcam Eagle 2 Pro. Tested the voltage trough the wires with a voltagemeter and wiring was all good. But if the FC has build-in OSD, shouldn’t i see it already in the goggles?
Hi! I’m new to fpv drones and i’m almost done with my first drones. I only have one last problem...
The goggles only give black screen and no OSD. I bought a speedybee F4 AIO flight controller wich and in my opinion, i soldered everything fine. And yes, i’ve put the black protector from the...