Recent content by tekgecko

Not quite sure why this is happening but my new build (first one) is slightly unstable and wobbles around when flying in horizon mode. Video here: When in acro mode it flies fine so not sure why this is happening. I have checked in CF and the gyro is just fine.

Got it working! But it was strange... see my previous post. Thanks for all your help you really helped sort it :)

Yes but whatever order I put it in, one of the channels is ALWAYS Aux1 or 4. Something seriously wrong here... Edit: Un-mapped channels 5 and 6 in my TX and it worked for about 10 seconds... clicked refresh on BF and it went back to incorrect mappings. Edit2: Okay so finally got it working...

How would I tell it to use Aux for throttle?

One of the sticks moves either Aux1 or Aux4 Just as a side note when you said 4AERT123 did you mean AERT1234 or will this make a difference?

The issue is whatever I change the mappings to, one of the channels is ALWAYS either Aux1 or Aux4 even when I match the display on the TX. It's so strange

Thanks very much I will try flashing BF. The correct protocol is being used in config (PWM) and it's my own brand new build. The CC3D I brought came pre-flashed with Cleanflight so maybe something was done in the factory? I know they are built for LibrePilot so I will try flashing Beta and let...

I have configured my quad in CleanFlight but no matter what order the pins are in the receiver, one of the channels is always either aux 1 or 4 when moving the sticks. Does anyone know why this could be?

I have a Falcon 250 pro quad: https://www.fasttech.com/product/615...r-c-quadcopter which I recently crashed and had to replace an ESC and motor ESC: US$8.99 VGOOD 20A 2-4S 32-Bit Brushless ESC With 4A SBEC for Fixed Wing RC Airplane RC Parts from Toys Hobbies and Robot on banggood.com Motor...

Okay fair play will give it a go

That's what I feared, the Gyro is in the FC so that would need replacing. I am quite new to acro mode still so like the option to switch back to a more stable flight mode

I replaced a broken motor and ESC of my quad (slightly different to the others I have on there but the same spec) When flying in acro mode it works perfectly, but if I switch to any mode that has auto leveling on it starts to wobble until it becomes unstable and crashes. Does anyone know why...

Great thanks for all your help!

No problem thanks anyway. How would you go about the calibration? Do you use cleanflight? If so I can find the parallels

Would this be just following the standard setup in Libre Pilot where you set the minimum voltage for each motor? Because I have done this already, or is there something else I need to do? Thanks!