Recent content by RPR

DS 92’ Bombs over Baghdad [emoji23]

T-Motor F7 & F45A V2 Shorted the ESC wire. Foxeer 3 lollipop antenna Dampen all my motors Ethix S4 props R9mm rx

At first, when I bought my first iFlight Nazgul5 4s version (since it’s cheaper) the ESC:45A 2-6S BLheli_S DShot600 was only able to accept 5s which was SHOCKING!!! Because on paper it said otherwise. At the time, since I had lots of 5s batteries and it accepted 5s batteries without VTX cut off...

I changed my ESC and that solved the issue.

Hello Gang, I replaced my iFlight Force long-range VTX to a Rush Tank Ultimate Plus VTX on my newly built iFlight XL 5 build. The Rush tank video feed is much cleaner, I am not getting an annoying horizontal black line from that the iFlight Force Long range generated, but my issue with the...

I’m not liking this thread right now [emoji23][emoji23] because I have been reallllllllly looking into getting into the DJI side of things

Thanks, bro. I have been flying my Buzz for 4mos now, my first 2mos was ugly, I crashed a lot [emoji23] but my goal is to go out, create, explore and see things in a different perspective. I still get nervous, but I just brush it off.

Early this month, I was having problems with vibrations. Vibration thanks to @rtkDarling for pointing me in the right direction. Last week, I finally sat down and try to solve my vibration issue and ran across a youtube channel by UAV Tech and also picked up bits of how to interpret my...

Hello gang, It's been a while... and it also has been a while, since I flew due to work and weather, but today I had the itch to fly and especially got to play around in BF's RPM Filtering. I'm flying my Emax Buzz, 6s, the quad feels really locked in, but..... After reviewing the footage...

check out this video. The concept is similar... Once you're familiar with you Tinyhawk, check out project hummingbird. PROJECT MOCKINGBIRD v3 for TinyHawk - Juicy Horizon version — Project Mockingbird

Check the modes tab are your aux setup correct?

Here’s from my r9mm..

Complete remove the filaments around the area where the button used to be. You can solder a wire and or use paper clip to short the terminal.

Hello gang, Here's an update. The stock wiring configuration on the Nazgul5 came cabled and neatly plugged to the aio. I was doing a bit more research and ran across this video that helped me out a bit. Here's what I did that eliminated the cutouts during throttle punchout, I eliminated the...