Recent content by RENOV8R

It's all just a guessing game until we know which flight controller and 4 in 1 ESC you are using and a diagram of how you have them connected

Unfortunate that this happened and I'm glad you got a refund. I think that BG has really upped their game and this doesn't happen that much any more. According to my account records, I've had 178 orders and about three years ago a $12 order never arrived. Not a bad record if you ask me...

St Thomas, a bit south of London

Welcome to the forum, where in Canada are you from?

Your wiring is OK but looking back on your posts, you're using ISRM internal mode which is ACCESS firmware. Have you updated to ACCESS firmware on your R-XSR as well?

The best drone to start out with for racing is one I've built;)

What model flight controller are you using?

Exactly. Then enable smartport in modes tab. Like this

I still think you need to move your yellow s.port wire to a different UART and enable in ports tab

You can't connect the sbus and s.port wires to the same UART

Great post! Did you get drunk? How ya feeling? hahaha

IMO the best AIO flight controller available is the Matek F722-SE

Looks good to me! Just too bad those white parts aren't blue

Glad you got it figured out! I've had to do this numerous times as the Radix FC has a habit of not outputting on S3 so I switch it to S5 pad.

Don't think so. As you have a FlySky transmitter, the only receiver compatible is the FS-R6B. But only puts out a PCM (1 wire per channel) signal which is not compatible with the Omnibus FC. It wants PPM or iBus signal