Recent content by Pmac_84

try this - should fix your problem

@HighTechPauper Thanks for the clarity! My terminology is still a bit poor.

Ha - yeah, i had the same issue.. mine was the other way around though. I've got a x220s so pretty sure we'll encounter the same issues along the way. Glad i could help..

Found the solution on RC Groups forum and also on GitHub - LED function is active from PWM5 (in my case, but can also be PWM6) not where the Omnibus F4 V3 board has LED labelled RC Group Thread - Report #365 Omnibus f4 pro - Page 25 - RC Groups GitHub Thread Indicator leds dont work right ·...

Would you say its insta-flipping on take off? I had a similar issue recently, not sure why it would've become an issue after replacing the esc though... I went through all the same trial and errors, calibrating, checking motors one by one, spin direction etc.. turned out i needed to offset my...

yeah, I've covered all of the basic steps.

by re configuring it i Beta flight - do you mean re calibrating the motors? If you haven't re calibrated the motors, this could be the issue

Thanks for the response.. I have tried different locations on the grid with no luck - i'm sure its something small i'm missing but just can't figure it out!

Hi All, Long story short - lost my x220, bought an x220s - all running fine, but i'm not sure about the LED tail setup... Am i wrong in thinking i should be able to config the LED's individually? and i'm sure i read somewhere that they're RGB?? They all light up white and the buzzer works...

So the problem has been solved!.... Credit to Voodoo614 on RC Groups - The Matek buzzer has to be wired differently to others - Matek 5V Buzzer Before rewiring the buzzer i did manage to get the lost signal beep working by switching to ibus over ppm, but this still didn't give me the lost...

This is why i'm so puzzled - everything to my knowledge is setup correctly... and i did stumbled across that forum with the USB plugged in but i have that setting on. I did connect lipo to vbat at the same time as it was part of a tutorial i followed - would this have anything to do with it...

lipo connection to VBAT

i'm fairly confident my modes are setup correctly..

No luck with that either - all of the other beeps still functioned correctly, but still no beeps on lost drone switch.

beeper GYRO_CALIBRATED beeper RX_LOST beeper RX_LOST_LANDING beeper DISARMING beeper ARMING beeper ARMING_GPS_FIX beeper BAT_CRIT_LOW beeper BAT_LOW beeper GPS_STATUS beeper RX_SET beeper ACC_CALIBRATION beeper ACC_CALIBRATION_FAIL beeper READY_BEEP beeper MULTI_BEEPS beeper DISARM_REPEAT beeper...