Welcome to FPVDronePilots!
Join our free FPV drone community today!
Sign up

Recent content by MPPilot

  1. M

    Battery Charger

    Once you get your charger you might want to check out the Crazepony 1S parallel charging board. I use it for my Inductrix batteries.
  2. M

    Los Angeles: Drone Race Track Antelope Valley

    I don't know if you plan to charge or not but you might want to check your homeowner's policy to see if covers injuries from this type of activity. I use to live in Canyon Country and would gladly make the trip, but unfortunately it is now a long drive from Philadelphia. :(
  3. M

    Project Blue Falcon Tributes...

    I knew nothing about JC and Project Blue Falcon until I saw UAVFuture's notice of his accident. I have since gone to his PBF channel and there is a great wealth of information there. I subscribed even though I know there will be nothing new coming, but it is all new for me. I would personally...
  4. M

    Quitters can't be racers...

    With my Taranis I just hook up a mini USB to the TX and plug it into my PC. No issues with this that I have noticed.
  5. M

    Quitters can't be racers...

    Interesting. Interesting. I'm assuming you send from the TX to the RX and the RX is connected to the computer by USB. Correct?, Picture is worth a thousand words. Now I understand. Thanks.
  6. M

    Quitters can't be racers...

    Can you go into more detail? I'm kind of confused about using a receiver with a sim. How does that work? I have both spectrum and Taranis and I connect the Taranis to the PC with a USB cord.
  7. M

    Quitters can't be racers...

    Thanks for the DRL simulator recommendation. Both fun and frustrating.
  8. M

    Quitters can't be racers...

    With a LOT of patience I have finally managed to get my overpowered X frame up in the air for about 30 seconds at a time under varying levels of control before it becomes a lawn dart. I have been flying LOS. Does putting on the FPV gear make it any easier to control or should I master FOS...
  9. M

    Help required for correct setup!!

    Make sure you are not using a charge only usb cable. You need one that can transmit data. Test by connecting your phone to your PC. If that works then it should work on your quad.
  10. M

    Beginning

    Before you spend a lot of money on something you might like I would recommend getting a cheap $50 drone like the Sima X5 series. It comes with a controller and you can practice basic flying skills before you start to sink a lot of hard earned money into this.
  11. M

    What did you do with your Quad today?

    I still cannot fly. I'm waiting for FuriousFPV to get back to me on a malfunctioning VTX board. Didn't matter too much when there was still snow on the ground, but it is gone now and I'm still waiting.
  12. M

    1 motor arms the other don't spool up

    Mark, In addition to checking the accelerometer check your radio sticks as well. When you add power (I'm assuming left stick) are you keeping it dead centered left to right? Are your sticks calibrated properly? I have noticed with mine that if my thumb slips a little left or right my quad...
  13. M

    each one falcon 250 pro

    If you go to the FliteTest YouTube page look for the xHover build. TJ does a great job showing how to get the proper drivers installeed and how to configure BetaFlight. It is toward the end of the video. If you watch the whole thing you will learn a lot about ESCs, PDBs, Flight Controllers...
  14. M

    I am in love with this hobby!

    Pretty good video. I'm still trying to figure out how to control my first home built. One recommendation, angle your camera up a little bit so you can see where the craft is going rather than looking down at the ground so much.
  15. M

    First flight done, time to post.

    Hi everyone. Took a racing quad I built out for its first flight. My first time flying a non-DJI product. Humbles one very quickly. Back to the simulator. Probably didn't help that there was a strong breeze blowing. Lots of dirt on the props but no harm, nothing broke. I'm guessing that's...