Recent content by Kian2552

Ah okay, were you all operating at the same power output? Also, what antennas are you using?

Nice one man, looks good! Are there any buildings in it to dive?

DSM2 and DSMX are both for Spektrum, so you don't want them. You will want one of the FrSky ones. To check if you have EU-LBT or non-EU go on your taranis, go to the model setup page (2/12 page) and go down to the bit that says MODE underneath INTERNAL RF. Scroll through the different modes...

Did you ask anyone else at the race if they had any issues? could be due to interference. Another thing to check is that your on the exact right channel, as i know the bands overlap with each other a bit, so you could be on 5805MHz on your receiver and 5800MHz on your vtx for example. Also...

Use nylock nuts and it should be fine. Also, you should be able to hear the prop slipping when the nut becomes loose if it does.

Hi guys, my friend who i fly with had an ESC go up in smoke on his eachine wizard, so we replaced the esc with the same esc as the others. However, now when it is flown it is under powered and cuts out at full throttle. Anyone got any ideas what could be causing this issue? Could the pdb be...

Hi guys, I got what I was told was a spektrum receiver with a drone on eBay, but don't know what model it is (I'm on frsky, but need to know as my friend is gonna be using it) If anyone could give me a tip on how to identify it or identify it themselves that would be appreciated. Cheers Kian

Hi guys, I had a propeller chop of half of ones of my antennas on my frsyk v8frii freceiver which uses two antennas. Every now and then my drone will lose all stick control, I think this could be failsafing but I believe it should drop out of the sky if it failsafes, at least thats how its set...

Here are the images :)

Hi guys, can anyone identify these ESC's? They came with some motors of ebay and i cant figure out what make/model they are. Also, anyone know how to check their amp rating if I can't find out what model they are. Thanks, Kian

Hi guys, I have an eachine wizard and I have replaced the pdb on it and since then one of my esc's makes half of the inital start up tones, and doesn't make the final beep. It also does not spin in betaflight when the rest do, I have tried swapping the esc to a different motor and different...

Hi guys, I have got an eachine wizard and had it flying great the other day and then landed it in a puddle by accident... Everything appeared to be alright except 1 esc. I replaced the ESC's with 20A afro ESC's. Now when i go into Betaflight motors tab, all the motors spin up when i use the...

I think it could have been part of the problem although it didnt solve my problem on my original board but changing the cable worked for another fligjt controller board with the issue. I am going to get around to aiming to fix the problems with my sp racing board when i get a chance. Although...

So I fixed this issue on my naze32 Rev6 board but not on my SP Racing board. If anyone else is in this situation try another usb cable, I was using a data cable but for some reason it didn't work for rebooting.

So I have tried using betaflight but I still get the same issue so I'm assuming its a flight controller problem? Is there any way of editing default settings on the firmware so I can just upload it with the settings already enabled?