Recent content by justin_b

Yep - lucky it was a quick cheap fix.

I have an 85x frame only. The camera was at fault. The power wire came loose under the betafpv sealant so it couldn’t be seen. I suppose while moving the camera/canopy around it I wasn’t pulling hard enough on the wire to get it to break free. I wasn’t getting any snow. Just a black screen with...

Thanx for the tips... i did try to resolder camera wires power ground etc, also tried to do as you suggested by adding the camera directly to the vtx out. Or did you mean onto the vtx itself? I have a tbs nano and not sure where to solder it tbh. I had the osd displays with a clear display. To...

Thanx. Will have a closer look. I did check if the wires had come loose but it seemed ok... it’d be a bit disappointing if the camera is dead after one crash... I’ve hardly flown this drone...

The problem seemed to be the motor wires rubbing in the bell of the motor... rerouted the wires and all seems fine now. Ive now got another problem. Im new to flying with only a couple hours total in flight time, so i crash. I now have no video in my goggles, recon v3 box goggles, if that makes...

I took it to the local drone supply store and they helped me fix the issue. Tried soldering onto the sbus pad again there but it didn’t take. So then put it on the rx2 pad and soldered a wire to the middle pin on the xm+ chip to get an uninverted signal as per the getfpv how to. We(they) then...

Hi all, Im busy with my first build - a beta 85x whoop frame , betafpv aio 12a f4, tbs nano pro vtx, frsky xm+ and a zo2 camera... Ive soldered everything up (terribly, not shiny and smooth like the yt vids :fear:) and theres power to all components (leds are lit) the problem is i managed to...