Recent content by Jimmyb-fpv

Man that worked! if only I'd of known about that way to do it thanks so much! Although my motors now all seem to fire up when armed they don't seem in sync two motors don't look like they are working at the same speed. I tried to fly it today and this happened (see video) it just spun in...

Yep done that but now my quad motors don't spin up at all?

Hey thanks for posting. Min Throttle is 1162 Esc set to 1152 as that's when they all seem to run smooth on the motor test in Betaflight When I power the quad up and arm it the motors don't spin at all until I increase throttle and then when I do increase throttle I have to move the stick about...

Hey everyone. So I've finished my 1st quad today. I have this set up. Armattan Chameleon Frame Matek F45 FC Matek PDB Cobra 2207 Motors Blheli 30amp Escs Everything's hooked up an kicking with regards to receiver video feed etc. So here's my problem, when I arm my motors only two of them...

Bump

Hi everyone. I recently built my first drone. Matek F4 - FC with Matek PDB Bleheli 30 amp Escs Cobra 2207 Motors On a Chameleon Frame. I went to plug in my battery yesterday and poof! I pulled it out quickly everything seems fine the voltage was not showing on betaflight before I pulled it...

Any ideas why me receiver would cause so much disruption to my video feed? Cheers

Hello... Just an update. I've just disconnected my radio receiver and guess what? My video feed is almost perfect! Any ideas on why this would be? I know it could interfere but what am I suppose to do about the receiver as I sort of need it :) Thank Jimmy

Thanks Jerry. Forgive my stupidness but the fatsharks just automatically connect to the correct channel don't they? Of is this something else I don't know about? Cheers

JT. Sorry man I appreciate your efforts to help me. How would I know if I'm not on the right channel or band? I can send you pictures of my set up later when I finish work if that's okay? Cheers JT

Hey. Yes I have bridged the connections just like in that diagram above. Is it possible that my jump solder is weak? I'm grabbing for any resolution here ?? :(

Hey thanks for the reply. I tried powering the camera through the VTX but I don't get a picture I can see the fc information through my screen but no video feed. At the moment I have the camera wired in to the fc. Yellow wire to video in black to ground. Vtx yellow to video out ground to ground...

Hi everyone. So I need some advice if possible. I have just built a new racing drone everything works fine apart from my FPV feed it's awful. I have a TBS unify pro vtx with a tbs triumph antenna my camera is a swift 2 all connected to a betaflight f3 fc. I have signal coming through to a...