Recent content by Hellindros

It's all good jerry , water under the bridge thanks for the reply , that's the thing about text , you can't see the tone behind the words unless it's obvious , it could have been just some light banter but I don't know him very well yet , I do respect his knowledge

Sorry kongkameltoe appears we high jacked your thread and turned it into a pissing match I may be new to this forum but am not new to the hobby I wish you the best this will be my last post here , and greenorange you need to be more humble trolling the forums trying to make people feel stupid...

Everything causes drag Drag is the aerodynamic force that opposes an aircraft's motion through the air. Drag is generated by every part of the airplane (even the engines!). Right from NASA, if he's adding a few streamlined pieces it will be insignificant , but if turns out chunky it can affect...

If it's not done right you can cause drag

I use the 3m duel lock tape on all my batteries, it holds the batteries great especially in a crash, i wouldn't bother with the foam it will affect your flying to much , just use small stick inputs arco is sensitive, try both thumbs and pinching, I pinch , if you lose control KiLL the motors...

Good luck dude , just remember you will crash and break something, it's part of the learning process

I would not use the goggles for a while , practice your Line of sight LoS , go to YouTube and look up RcAddict he has the best Line of sight videos tutorials out there

I would recalibrate the AT-9 controller as well , here's a link on how to do that ,

What model of xspeed did you buy , looking online to get a better idea of the components your drone has , most of the rtf drones by arris come tuned from the factory according to their website , have you contacted them for support , keep giving us info Greenorange will figure it out

For the calibration you have to use the chrome app on a windows Pc with normal micro USB , there is a android app version but that is for tuning PiDs only , great for tuning in the field but can't do any Rc controller setup / or drone setup , for that app to work you need a otg cable plus a...

I would stay away from the tramp because is high voltage component , it's not a good idea to mix HV components with non HV components, everything else in that list are good non HV components so I would change the Vtx to TBS unify pro v2 , it's one of the best you can get

Didn't look up model of receiver , so your post is the correct way to go , good luck fiddlebog ,

PWM, PPM and SBus are types of signal protocols , the previous post is the proper way to go , SBus is the better signal over PPM , so only use 5+ , ground and SBus , isolated the PPM wire , look up the pin diagram for your model of flight controller, it will show where you need to solder the...