Recent content by Gurke34

That worked somehow ... thanks a lot ! :) Not sure what exactly was wrong but it works now hehe

I just checked that too - FS isn't active, the parachute is grey. Really starting to wonder what else I can try to fix that :D

100% sure yes - I checked it in the "modes" tab and could see the switch value moving on the arming channel.

Gyroloop is 8khz and PIDloop is 2khz - I didn't change them from stock settings. Neither of the models are drifting and I plug in the battery while the quad already is on a level surface. Unfortunately, the result was the same with accelerometer turned off - didn't work.

What do you mean?

Thanks for you answer :) Yes I already tried everything in his video and accelerometer is leveled. I‘m running dshot600 and yes I do use a failsafe. How would the failsafe stop the quad from arming?

I just received my Lizard 95 and tried to set it up. So I configured all the usual stuff in betaflight which worked fine so far. Once I finished and tried to arm it, it didn't arm but started to beep (see in the video). The aux is configured correctly and works in the "modes" tab. I enabled...

Thanks for the answer :) Somehow the video won‘t process... I know where I can test the motors but I‘m not sure where to set min throttle? If my min throttle is 1100 for example but the transmitter output at zero throttle is only 900 - will the motors spin „at 1100“ then? Is there a certain...

Motor stop is unchecked. I don‘t have any more AUX left on the transmitter, that‘s why I have airmode enabled always. But I learned to land more or less with airmode enabled on the old quad. When I arm the quad the props don‘t move until I do an input. But if there is no input and I tilt the...

Yess it works now! Thanks for your help. I had to exchange the white cable with the yellow cable and connect it on the PPM Port at the receiver as you said. I also had to dissolve the tin from the SBUS thing (red arrow) and do some tin on the PPM thing (green arrow) to make it work. (Not done...

Whoops you‘re right :D Looks like I connected the wire to ibus/sbus. Trying to reconnect it correctly tomorrow :D I‘ll keep you updated about the result - thanks for the help :)

It‘s a new Wizard 220s but it came delivered without any transmitter. So I‘m trying to install one :)

hello again I just installed the FS A8S to my Wizard 220s and connected it by PPM. I could successfully connect my Flysky FS i6 to the transmitter. However, the drone won‘t recieve any input... I tried to rebind to transmitter/controller multiple times (binding worked but still no input). The...

thanks for the fast answer :) I just haven't figured out which ports to use on the platine yet :D I'll switch later

Hello there. I just bought a Wizard 220s (2nd Drone) and figured out that it came without a reciever. I still have a FlySky FS-i6 that I want to use with the Wizard. So I was thinking to buy the FS-A8S Reciever to build into the Wizard Flysky FS-A8S FS A8S 2.4G 8CH Mini Receiver with PPM i-BUS...