Recent content by graywoulf

I'm outta here. See ya around!

Yes, I did have a question that was unanswered but that is OK. Seems that I would have gotten some kind of response but the question was not even read. I am not concerned about it though. I wish that there was a way to delete a thread here though. Thanks for asking.

Seems that this forum is pretty dead... what a shame.

I use Liftoff quite a bit and find it useful and fun. But Steam support can be a hassle at times for sure.

You may have uploaded this a long time ago but this is proof that doing a search for information pays off even today. Most helpful! Thank you.

Hey guys, After giving up on my Beta 65s micro quad, I unboxed my HGLRC Sector 132 cinewhoop to get it ready to fly. Everything is going smoothly except when I connected the quad to Betaflight, while in the receiver tab I noticed that my radio's three position switch "B" affects the pitch of...

So, to finish up this thread. I bought a new FC board for the quad and had it flying but the connector block for the FPV cam did not come with the new board so I transferred the connector from the old board to the new one. After that, the new FC fried itself so I am done with this quad. I...

Thank you very much for your input on this. I think that Dan has pretty much nailed the issue being the voltage regulator on the FC board. I am going to write this board off and look for a replacement for it.

I did not have the battery attached at the same time the quad was connected via USB cable. There is a red LED on the FC board that used to flash that I think was an indicator to tell if the FC was armed or not armed. It no longer flashes. I think you may be correct with your observation of a...

Thank you for your information. Since I first started this post, I was trying to do a fresh CLI dump and something went wrong. The quad would not connect to Betaflight at all so I did a firmware flash and fixed the connection issue but now I can't get the quad to bind to my TX-16S radio. When it...

Thanks for the tips. I will clean the board with alcohol tomorrow.

I do not have a way to do that right now. Besides, the FC board is tiny.

I have tried several batteries. The main thing is that the motors will not spin up in Betaflight using power from the USB cable when it is connected in that manner.

I have reflashed the firmware and installed the original factory CLI files as well. Now, I can't get the quad to bind to my TX-16S radio. I flashed the firmware with an older version from 11/2020 which is around the time I bought the quad. If I did not have so much money involved, I think I...

Hey guys! It has been a while since I was here but I hope someone can help me with my Beta 65S. I have not flown it in a long while but decided it was time to have some fun with it. At first, I could not get it to bind with my TX-16S radio as I had forgotten the settings and I am still not sure...