Recent content by Gin

ok thank you very much so i can heatshrink even the last part of the antenna that's good i'll do that, thank you again for the fast response

Hi everyone, so i finally hot into fpv and in my very 1st Flight i got problems, One of my antenna hot sucked into a propeller, than i fixed the antenna and mounted in a differenti way and that worked out but i May Need to get a Crossfire module cuz the enviroment where i fly it's causing me...

yep i connected the lipo, the blob of solder that you are saying by looking closer it's not touching anithing else but i dont know if it's shorting something

yep you are right i'll look for something like it. thank you again

i wasn't able to read the esc or spin the motors since i had never solder besofore all the solder looks pretty bad, i am already amazed that something is working and not everything is toasted so i may have fried someting for sure below the esc connection point( if you heve a weak hearth please...

ok so i was able to flash the FC(using the bl command on cli tab, i run impulse rc anyways ) but still i cant read any esc in BLHeliSuite and motors dont spin. and getting the same error as before

The full chip erase Tab was checked. I dont thing i understod the First part, in the flash firmware Tab i select the version that i want to flash, the FC is on dfu mode i can't connect to ant port, the file is loaded and if i click flash at the bottom or the page nothing happen...anyway i Will...

Ok so First time i forgot about dfu mode, then i uses a button to get into bootloader mode, the led acted differently, but in this mode i can't see the com port at all. I did not tried the ImpulseRC Driver fixer cuz i didnt know about so i Will try this

yep the battery plugged in and charged the 1st bootloader not work at all, the second show the below tab that it will go forever i now tried to flash the fc but it is not working even that and when i hit flash firmware i lose the connection with com9

in my case everything helps so thank you, will follow the screenshot , i think that's right but i dont know maybe i miss something

i had the oneshot125 setted on the first try, and then i tried angain but nothing, now i was using BLHELISuite/BLHELISuite32 to read the setup/flash blheli but nothing the 4 esc label were empty, i think at this point that i have fail something while wiring

Yep, the bars in the reciver Tab are moving as i move the stick

Hi thank you for the fast response, unfortunately i couldnt bè that fast since i was i Brasil and i read but could bot answere cuz bad WiFi, so i checked the swirch for props off, the battery was plugged in and i heard 3 toner( are those enouth?) Is It possibile that failing 1 wiring cause all...

hi this is my 1st fpv drone build and i am having some issue with motors/ esc. i mounted a Matek AIO F4 Flight Controller + PDB 4*30A + Bateflight OSD, motors Emax RS2306 - 2400KV, esc T-MOTOR F30A ESC-BLHeli 32BIT-2S-4S - DSHOT 1200 the reciever bind, i have the video on goggles, plugging the...