Recent content by Fowl Play

And you have spare parts now! I think I have a couple builds worth of spare parts by now lol

Also, check the diagram the shows the light sequence on the vtx board, and confirm the channel it says it's on according the the board's lights and not what betaflight says. If your SA isn't working you would have to use the board buttons to change vtx channels

Yes like the other guy said. Check the vtx connector(s) carefully. Make sure they don't move if you lightly put tension on them. I recently had this problem with a larva x which is made by the same company and it was fresh out of the box. I found when I moved the vtx wire while my goggles were...

Good luck!

Maybe try betaflight on a different device? This sounds crazy but my chromebook has worked more steadily across all drones but on my pc I can't use cli commands on 3 of my drones.

Emax made good on the transmitter but it's just sitting ont the shelf as a backup. I've moved way beyond it by now lol. The TH3 quad itself has stood up to quite the beating I might add. It's been submerged in water 3 times now and still no problem flying.

That is unusual that you would get 2 tinywhoops and have those results. I have only own 3 tiny whoops and one small "freestyle". 2 emax products and 2 geprc products. I have put these things through hell and they keep working. Just lost rx midflight on my freestyle (was way higher than I should...

Once in correct mode bind again and then you may have to go to betaflight after that to make sure mapping is correct etc etc

Note, I looked up your drone. It looks like I see 2 variants for rx protocol, frsky and tbs crossfire. So you may need to know which one you have and switch your controller to that mode. Could be frsky d8 or frskyd 16 and your controller will have a way to switch in those modes. If your drone is...

Hello! I am not by any means an expert. I am pretty inexperienced myself especially on digital. But you may need to do any one number of things before being able to fly when binding to a new controller. You will likely need to download betaflight if you haven't already. You may need to map out...

Was the mod to run multiprotocol easy? Or do you only fly crossfire? I'm newish to the drone hobby but not new to being a 🤓 nerd.

How do you like the tango 2? I'm torn between the tango and jumper t-lite leaning towards t-lite but mostly because I won't be able to hold either I my hand before buying

Agreed to some degree. I'm not sure about the best but only because of limited experience but that's why I emphasized the the weak point in this RTF was the transmitter, and that I like how durable the drone is itself allowing me to push my limits because of its well built construction and ease...

Not sure what caused your issue, but I can say the solder points around gimbals, material and craftsmanship on the E-8 transmitter, are toy grade. I opened mine after learning I was on my own because the Amazon seller wasn't an authorized dealer. I can probably just solder this up and be on my...