Recent content by Calihulk

After trying for several hours I was unsuccessful trying to upload the new system it says that I needed to press the Boost button but I don't have one thanks again for all your help I will try to figure it out or buy a new CC3D board or if you recommend a better one that would be great.

Thanks for all you're help. I will try that and let you know how it goes thanks again. I really hope this works.

Is there a step by step setup

I don't know. On the update for some reason it didn't want to arm. BUT how do I do this How do I do this

Just binded it no go still. So frustrating could the CC3D be bad.

Well I think it is but since I just updated the system I can do another bind.

I really appreciate all the help. It is a PWM that's the way it.was installed from the update.

Sorry but how do I now which one I have I really don't know all the technical names.

This is more complicated than what I thought !!!!!!!

I did a step by step set up last night everything on the drone worked fine when conectes to the computer. when I was done setting it up the control still couldn't connect to the Drone. My control is a devention devo 7. The blue light on the CC3D just blinks but doesn't change when I give It...

Shoup be running another program?

I really couldn't tell you, the update was 15.9 I believe black rhino

Just updating on my drone problem. I updated the CC3D last night everything there seems to work. But the control doesn't seem to be connecting. The controller is a devention devo 7 setup. The blue light on the CC3D doesn't change when operating the remote it stays blinking even if you're...

Thanks Wayno50, I purchased it from a friend that acquired it from another person. He didn't know much about it he tried turning it on and unfortunately didn't take off the propeller blades and cut his hand. So he didn't want anything to do with the Drone. I believe it is a storm 250 but that's...