Recent content by Br3ckon

Hey been havung a problem for a while of my controller not connecting to the drone and it not showing up on cleanflight. Any help would be amazing

I have had a similar problem for a while my problem is the controller does not do anything once connected. From my understanding the reason the controller does not say bound is because the receiver in its current state is one way, I e controller to receiver so it would never send a signal to the...

I have a soldering iron, not very good, my receiver not been working on current one, my flyky remote is working I bound it to another mini quad I have, however when I try to re-bind to the wizard the remote just doesn't work tried everything to fix it, I'm just think of getting a new recover to...

Hello all, Anyone have any recommendations to upgrade the receiver in the 220s to a better one, that can connect to flyky remote and is not to difficult to install? Thanks all

Hello, I have a wizard 220s with flyky remote, was working fine, I bound my flyky controler to another drone, when I tried to re-bind the remote it, is no longer doing anything doesn't arm doesn't show up on betaflight. I followed instructions only to do this, it says receiver should flash...

As title says I am building my first drone just the e010 build soldred the battery wire to flight controller screwed in the flight controller to frame plugged in motors but when I out battery on one motor goes full power and the RC controller does nothing even though I know is connected through...

All i want is an acrro micro drone to practice flying acro fpv i found this build online on banggood i dont know if you know one i could use i got dji spark, eachine wizard 220s wanted to build my own, a build guide would be awsome

Most likely 1s but depends what would you recommend, just read brushless moters are better what you reccomend

Ok so I feel I'm getting it now. So I can add camera to 5v but if camera is 200mah, the motors are 250mah and reciever is 40ma need to make sure the flight controller can take the power of 490 mAh, I looked on the flight controller description and didn't find a max voltage. Where would I find...

Can I solder the camera to the 5v uart in this to give the camera power

I have seen some flight controller with cam plus and minus on though?

Hello, I've been looking at building my first quad a FPV mini one. Been looking to build from the q100 kingkong frame found everything else seems straight forward but I'm confused to to connect the camera to the flight controller. I plan to use Eachine 32bits F3 Brushed Flight Control Board...

Haha makes a lot of sense my bad. Thank you

Hello all, I've Been looking into making a mini quad but I want it to fly acro, ice seen a few videos of people making the drones but they skip over how they connect them to betaflight. Don't know if this is an obvious question but any help would be welcomed. Thanks Br3ckon P.s never built...