Recent content by BillDebevc

Change of pace today. I decided to make a cave / mine exploring drone. I am using these parts to make a drone in a sphere. Still have a bunch of work designing the Sphere but I am getting there. Once of the goals to to build it on the cheap so when I loose it, I can just build another and...

At least if I let the smoke out it will look cool flying with smoke trails, and it would be easier to find.

The motors are 1104 7500kv. I might let the smoke out but we will see. I got extras.

Here is my progress so far. I have some 3d designing and printing left to do. In the front is a 5 volt regulator and a 330 cap. This will power the FC, Receiver and Camera. This way I can run 3s.

Here is the part list: Note: I have not built this thing yet so the parts may change as I build it. This is what I have so far. Frame: Awesome E90 Motor: 1104-KV7500 Props: Racestar 2035 50mm 4 blade FC/ESC/Raido: Eachine Mini Cube 20mm X 20mm OSD Camera: CM275T 5.8g 25mw (don't know about...

Squirrel! Side tracked again with new build. As always I am drawing everything in AutoCAD first. The photos below have a 5x4.5 prop in them for size. This thing it TINY.

Here is what I have for the day. I think this is going to be the base to build the rest. Kind of like the idea of offsetting the arms vertically, like my Mavic. This will work with 5" (inner circle), 6" (mid circle), 6.5" props (transparent circle). Also changed the battery to a 1800 70c 4s...

Here is what I have designed so far. I picked up a Betaflight F4 AIO Flight Controller. Need to draw up the motors and FPV camera system. Then design housings for everything. I also need to start calculating center of mass to see if where I want it to be.

Just ordered one. Thanks a lot. :)

Found the motors, AmaxInno 2305 2550kv impressive specs @theGreenOrange my printer only support PLA. I have a Mod-T printer

I have been reading good things about the Raceflight motors

Here are the AutoCAD 2017 DWG files of the Top Plate, Arms and Camera Mount.

Armed with AutoCAD and a 3D printer and fresh after my ZMR-210 build I am starting on a very custom ZMR-250 build. I will post my progress over the next few weeks or months on this thread for those who are interested. I am looking for constructive feedback so don't be shy. I will also attach...

Oh, that is something isn't. I guess we will see if the 5v power regulator gets hot.

Couldn’t you just wire the power from the PDB?